"There is not enough memory to complete the operation.
To increase available memory, close open documents or quit and increase virtual memory to aloud more memory for flash."
I am not a computer genius, so I'm not sure of what happened, but i had no open documents at the time and i followed some steps from the internet about going to control panel and stuff to increase virtual memory and after restarting the message still appeared....
There are two documents i cannot open, well they open, but the timeline and workspace are in blank and if i click in there the message appears.
What I was doing is: I make a scene of my flash in a document and then copy and paste the frames in one i'm putting all the scenes together, i dont do all the scenes in the same document cause flash then turns all slow and crappy, but that's another story.
What happened it that when pasting the frames my computer crashed, i restarted, tried again, it crashed, i tried like three times until before restarting i could click on 'save' and i'm not sure if it saved, cause the next time i tried the message appeared..
What can I do?
-thanks