Score: 7
"none too shabby"
date: January 11, 2009
you should whack the default compressor on the master bus and pull the value on the fader to a little under 79% cause there's some mad clipping when you start to lowpass filter everything.
I very rarely use reverb on bass drums or bassey instruments in general, but if you leave it on here then i'd suggest pulling the low cut value to somewhere like 500Hz. reverbing low frequencies can make an otherwise clean mix start to get very messy.
did you had extra treble to those hats? they seem extra thin and toppy.
i really like the warm pads and the wide bassline. could use a fair bit more variation on the whole but this is some nice ambient tech backing music at the moment.
keep it up :)
February 8, 2009
Author's Response:
Yeah, true.
The hats were a special pack and I added a special FX to them and stuff. A stereo enhancer. Some sort of EQ, I'm sure. I dunno. I toy around with it a lot.
I'm glad you enjoyed it, though.